19

2022

-

08

Laser Cutting Machine N2 3LPM PSA Nitrogen Generator Installation Site Requirements


Laser Cutting Machine N2 3LPM PSA Nitrogen Generator system equipment generally has no site foundation requirements, as long as the floor is flat in the workshop, it can meet the installation conditions. However, for larger specifications of air compressors, compressed air drying equipment, etc., it is implemented according to the requirements of the manufacturer. For the convenience of equipment maintenance and cleaning, it is better to make a flat table 10cm above the ground in the placement position of the air compressor, drying equipment, nitrogen generator and nitrogen purification device.

Laser Cutting Machine N2 3LPM PSA Nitrogen Generator
Laser Cutting Machine N2 3LPM PSA Nitrogen Generator The manufacturer tells you that the air compressor and the air dryer should be placed on the upper air vent or in a well-ventilated place. If there is no air storage tank behind the air compressor, the air compressor and the air dryer should be The distance should be as large as possible, and the length of the pipeline between the two should be as long as possible, so as to reduce the temperature of the compressed air through the atmospheric environment. The manufacturer of Laser Cutting Machine N2 3LPM PSA Nitrogen Generator tells you that the distance between each device should be at least 1m, the distance between each device and the wall should be at least 0.8m, and the operating surface of the device should face the direction that is convenient for personnel to operate the device. and maintenance and overhaul.
The manufacturer of Laser Cutting Machine N2 3LPM PSA Nitrogen Generator tells you that the pipeline connection between the equipment depends on the actual situation after the equipment is in place. It is recommended that the pipeline connection be made by the user according to their needs. The articles described above are for reference only! The specific situation needs to be analyzed in detail!

相关新闻